Introduction; Additional Accessories - Epson AP-60 - Projector Sound Solution Installation Manual

Introduction

Before installing the AP-60, you should perform the following steps:
• Run all wiring required for the audio and power connections for the AP-60 and projector.
• If you have a projector already installed, remove the projector from the 1.5-inch mounting pipe and remove
the old mounting pipe. If you aren't installing a projector with the AP-60, make sure you have a ceiling
mount compatible with a 1.5-inch NPT mounting pipe installed.
Parts List
Before starting, make sure you have all the parts listed below. If you're missing any parts, contact Epson as
described on page 26.
AP-60
Lower bracket
Mounting pipe
Note
The included installation hardware is designed for a 1.5-inch pipe mount. You may need additional hardware if your setup
varies.

Additional Accessories

You can purchase projectors, screens, or other accessories from an Epson authorized reseller. To find the nearest
reseller, call 800-GO-EPSON (800-463-7766). Or you can purchase online at www.epsonstore.com (U.S. sales)
or www.epson.ca (Canadian sales).
To order an additional pendant microphone, request part number V12H3290M1.
Pendant microphone
Power cable
M10 bolt and nut
M47.5 jam nut
9
Neck strap
Remote control
Guy wires
IR dome sensor
LR6 (alkaline)
AA batteries
R6 (manganese)
AA batteries
Coaxial cable