Brother BAS-311E Service Manual page 27

Feed mechanism (Y axis) (3) 326E, 326E
r
w
e
1. Secure the slider support shaft w of the work clamp assy q using the supplied set screw e.
(To prevent the slider support shaft w and the slider r from suddenly protruding, be sure to do this job.)
2. Loosen the set screw, and remove the X-feed shaft t.
3. Remove the two bolts, and the work clamp assy q.
4. Remove the two bolts, and X-feed shaft support 326 y.
5. Remove the four bolts, the Y-feed pulse motor bracket u, and the Y-driving shaft i.
6. Remove the two bolts, and Y-feed bracket cover F o.
7. Remove the four bolts, Y-feed guide assy 326 !0 , cross roller 326 !1 , and the Y-feed bracket !2 .
8. Remove the eight set screws, the X-feed bracket !3 , and the linear guide !4 .
q
q
t
!1
BAS-311E.311EL.326E.326EL
i
!0
!2
o
!3
!4
Chapter 2. Disassembly
u
y
19