Work Clamp Lifter (Solenoid Type) - Brother BAS-311E Service Manual

9. Work clamp lifter (Solenoid type)

e
w
1. Remove the spring q.
2. Remove the screw w, and the presser solenoid e from the plunger r by lifting the latter from above.
Be sure to hold the plunger r securely so that it does not fall.
3. Remove the snap pin t and the rod y.
4. Loosen the set screw u, and remove the snap pin i, link shaft A o, and the washer !0 .
5. Remove the rubber cap !1 , the snap pin !2 , and link shaft C !3 .
Be sure to hold the presser plate ! 4 and the presser bar lifter lever rubber ! 5 so that they do not fall.
6. Remove all parts connected to the plunger r by lifting them upward.
o
u
i
!1
!3
BAS-311E.311EL.326E.326EL
!0
q
!0
t
q
u
Chapter 2. Disassembly
e
y
i
r
!2
o
!5
!4
r
23