Brother BAS-311E Service Manual page 95

Memory Switches (00 – 0F)
SW No.
When moving to the home position, the feed plate moves in the order X
memo-00
When moving to the home position, the feed plate moves in the order Y
memo-01
The forward position becomes the home position, and movement is in the order Y
memo-02
DIP switch A-7 is set to ON. Cassette is held by automatic ejector and the sewing machine
memo-03
memo-04 Needle stops in up position during emergency stop: (Needle normally stops in down position.)
memo-05 When sewing is finished, the feed plate moves via the machine home position to the start position.
memo-06 After the final stitch, the work clamp rises and then the feed plate returns to the start position.
memo-07
When using an alternating clamping presser (1/4 ON, 3/4 OFF), and when sewing overlapping
memo-08
memo-09
memo-0A
memo-0b
memo-0c
memo-0d
memo-0E Test feeding is carried out at the same speed as normal sewing. (For checking feed operation)
memo-0F After sewing is finished, the work clamp automatically opens and closes once (practice operation)
Memory Switches (20 – 2F)
SW No.
During feed test operation, feeding 100 stitches at a time is possible using the STEP BACK
memo-20
After the home position is detected and the machine moves to the sewing start position, the
memo-21
memo-22
memo-23 Set to ON when the bobbin changer is being used. (This part is available by special order.)
Note:C indicates that these functions are available for software versions MN-C or later.
Automatic ejector operates. (It is available by special order.)
Intermittent work clamp is not used (does not rise).
Wiper is changed to pneumatic wiper. (Pneumatic wiper is available as an option.)
Jog feeding becomes faster during programming.
ON when a two-stage tensioner is used. (Two-stage tensioner is available as an option.)
Single-pedal operation by means of two-stage work clamp switches. DIP switch A-2 is ON
Clearing the emergency stop switch action is carried out using the STEP BACK switch.
When extended option output No.1 is ON, the sewing machine starts automatically.
BAS-311E.311EL.326E.326EL
Chapter 6 Power supply and electrical parts adjustment
When ON
moves in the order Y
moves in the order X
Used for attaching buttons.
automatically starts.
rectangles.
When ON
switch.
work clamp rises automatically.
Y and the start position
X.
X and the start position
Y.
X and X Y.
ç
ç
ç
ç
87