Fujitsu MHM2100AT - Mobile 10 GB Hard Drive Product Manual page 121

Interface
At command issuance (I/O registers setting contents)
1F7 (CM)
H
1F6 (DH)
H
1F5 (CH)
H
1F4 (CL)
H
1F3 (SN)
H
1F2 (SC)
H
1F1 (FR)
H
At command completion (I/O registers contents to be read)
1F7 (ST)
H
1F6 (DH)
H
1F5 (CH)
H
1F4 (CL)
H
1F3 (SN)
H
1F2 (SC)
H
1F1 (ER)
H
After power-on or after hardware reset, the READ MULTIPLE and WRITE
MULTIPLE command operation are disabled as the default mode.
The mode established before software reset is retained if disable default (Features
Reg. = 66h setting) has been defined by the SET FEATURES command. If
disable default has not been defined after the software is the READ MULTIPLE
and WRITE MULTIPLE commands are disabled.
The parameters for the multiple commands which are posted to the host system
when the IDENTIFY DEVICE command is issued are listed below. See
Subsection 5.32 for the IDENTIFY DEVICE command.
5-44
1 1 0 0
x x x DV
xx
xx
xx
Sector count/block
xx
Status information
x x x DV
xx
xx
xx
Sector count/block
Error information
0 1 1 0
xx
xx
C141-E104-03EN