Fujitsu MHM2100AT - Mobile 10 GB Hard Drive Product Manual page 131

Interface
At command completion (I/O registers contents to be read)
1F7 (ST)
H
1F6 (DH)
H
1F5 (CH)
H
1F4 (CL)
H
1F3 (SN)
H
1F2 (SC)
H
1F1 (ER)
H
*1 If the command is terminated due to an error, this register indicates 01.
(20) WRITE LONG (X'32' or X'33')
This command operates similarly to the READ SECTOR(S) command except that
the device writes the data and the ECC bytes transferred from the host system to
the disk medium. The device does not generate ECC bytes by itself. The WRITE
LONG command supports only single sector operation.
The number of ECC bytes to be transferred is fixed to 4 bytes and can not be
changed by the SET FEATURES command.
This command is operated under the following conditions:
READ LONG issued
•
(After READ LONG is issued, WRITE LONG can be issued consecutively.)
If above condition is not satisfied, the command operation is not guaranteed.
At command issuance (I/O registers setting contents)
1F7 (CM)
H
1F6 (DH)
H
1F5 (CH)
H
1F4 (CL)
H
1F3 (SN)
H
1F2 (SC)
H
1F1 (FR)
H
5-54
Status information
x L x DV
Cylinder No. [MSB] / LBA
Cylinder No. [LSB] / LBA
Sector No. / LBA [LSB]
00 (*1)
Error information
WRITE LONG (Same address) issues sequence
→
0 0 1 1
x L x DV
Cylinder No. [MSB] / LBA
Cylinder No. [LSB] / LBA
Sector No. / LBA [LSB]
01
xx
Head No. /LBA [MSB]
0 0 1 R
Head No. /LBA [MSB]
C141-E104-03EN