Figure 3.3 Mounting Frame Structure - Fujitsu MHM2100AT - Mobile 10 GB Hard Drive Product Manual

(2) Frame
The MR head bias of the HDD disk enclosure (DE) is zero. The mounting frame
is connected to SG.
Use M3 screw for the mounting screw and the screw length should
satisfy the specification in Figure 3.3.
The tightening torque must be 0.49N·m(5kgf·cm).
When attaching the HDD to the system frame, do not allow the
system frame to touch parts (cover and base) other than parts to
which the HDD is attached.
(3) Limitation of mounting
Do not use the center hole. For screw length, see Figure 3.3.
Note)
Bottom surface mounting
2
A
Frame of system
cabinet
3.0 or less
Details of A
C141-E104-03EN
IMPORTANT
These dimensions are recommended values; if it is not possible to
satisfy them, contact us.
2.5
DE
Screw
3.0 or less

Figure 3.3 Mounting frame structure

Side surface
2.5
mounting
2.5
PCA
Frame of system
cabinet
Screw
Details of B
3.2 Mounting
2.5
B
3-5