HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual page 146

Chapter 14
Configuration of NVRAM and drives mismatch for:
HA-0(Legacy Array Found)
HA-1(Legacy Array Found)
Run View/Add/Delete Configuration option of Configuration Utility.
Press any key to enter the Configuration Utility.
Problem: You have installed more than one adapter, and the configurations
stored in the drives are from a legacy controller (1Si or 3Si). All drives contain
one set of configuration information, and NVRAM contains a different set.
Suggested solution:
1. Press any key to enter HP NetRAID Express Tools.
2. From the Configure menu, choose the View/Add/Delete Configuration
option. The View/Add/Delete Configuration option asks which
configuration you want to view: NVRAM or disk. Choose disk. Select
Yes to migrate the configuration.
3. Repeat for each controller.
Unresolved configuration mismatch between disk(s) and NVRAM on the adapter
Problem: The configuration stored in the adapter's NVRAM does not match the
configuration stored on the drives, and configuration information on some drives
conflict with configuration information on other drives.
Suggested solution: Do the following to reconfigure your drives and restore you
data.
1. Press <Ctrl> <M> to start HP NetRAID Express Tools, as described in
Step L in Chapter 6, "HP NetRAID Software."
2. From the Configure menu, choose the View/Add/Delete Configuration
option.
3. Use View/Add/Delete Configuration to examine the configuration stored
in NVRAM. Write down all configuration information, including the
SCSI IDs of the physical drives in each array, the array and logical drive
numbers, stripe size, logical drive size, and the adapter settings.
4. Clear your configuration and reconfigure all of your drives using one of
the HP NetRAID utilities (HP NetRAID Assistant, HP NetRAID Config,
or HP NetRAID Express Tools). See the HP NetRAID User's Guide for
more information.
5. Restore your data from a backup copy.
138
Troubleshooting