HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual page 82

Chapter 6
Microsoft Windows NT Terminal Server Edition
NOTE
Windows NT Terminal Server Edition must be operating in
INSTALL mode when you install the NetRAID Software—
NT/Win2000. Otherwise, the administrator may see it as
properly installed, but it may fail for other users.
There are three relevant commands for the DOS prompt:
After the installation, return to the default EXECUTE mode.
This means that clients connected via the network can
connect to the server and run Windows NT sessions from it.
1. Select Start from the taskbar.
2. Choose Run from the Start menu.
3. Insert diskette #1, "NetRAID Software—NT/Win2000."
4. Type <d>:\setup at the Open: prompt, where <d> is the drive letter of
the diskette drive you are using.
5. Follow the on-screen instructions.
NOTE
Setup installs the following HP NetRAID-1M or 2M software:
74
CHANGE USER /INSTALL = sets it to install mode.
CHANGE USER /EXECUTE = sets it to execute mode.
CHANGE USER /QUERY = show the current mode of
operation.
HP NetRAID Assistant
HP NetRAID Monitor Service
HP NetRAID Consistency Check Scheduler
HP NetRAID Software