HP P3410A - NetRAID 1M RAID Controller Installation And Configuration Manual page 77

Chapter 6
2. Insert the HP Netserver Navigator CD-ROM into the drive. HP Netserver
Navigator should start automatically if automatic startup is enabled for the
CD-ROM drive. If not, double-click launch32.exe on the CD-ROM to
launch HP Netserver Navigator. It looks different from HP Netserver
Navigator running on the HP Netserver.
3. On the Netserver Navigator screen's drop-down menu of HP Netservers,
click the HP Netserver you are configuring. Then click the arrow in the
lower right corner of the screen.
4. On the Netserver Navigator menu of NOSs, click the NOS you plan to
install. Then click the arrow in the lower right corner of the screen.
5. The Netserver Navigator Main Menu is displayed. Click Guide to
Configure Server.
6. The Guide to Configure Server list the following items:
NOS Installation Instructions
Tested Configurations
Diskette Library
Click NOS Installation Instructions. Then click the appropriate icon
either to save the instructions to diskette, or to print the instructions.
Follow the onscreen instructions. When you have finished saving or
printing, click the Close arrow.
7. On the Guide to Configure Server screen, click Diskette Library.
8. On the Diskette Library screen, double-click the NOS drivers for the NOS
you plan to install. Then follow the onscreen instructions to create the
diskette.
9. Go to "Make NOS-specific Configuration Utility Diskette" later in Step I.
Using the HP Netserver to Create Drivers Diskette and Instructions
To use the HP Netserver you are configuring to create the diskette(s) containing
the drivers for your NOS and the instructions for installing the NOS, do the
following:
1. Turn on the HP Netserver and monitor, if they are not already on, and
insert the HP Netserver Navigator CD-ROM into the drive. Turn off the
HP Netserver power, wait 10 seconds, and turn it back on again.
2. From the HP Navigator Main Menu, choose Configure the Server.
HP NetRAID Software
69