HP Vectra VL6 6 Installation Manual page 13

Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2.
• 3COM Etherlink 3C900 Ethernet card and drivers disk Ver. 2.1.
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
• I/O Base Address
• Interrupt Request Level
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink 3C900 adapter
2 Connect network Cable media to the 3COM 3C900 card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM drivers disk 1 "Etherlink 3C900 Ethernet
5 Select "Configure NIC," and verify the resource settings listed above
6 If changes are required, save those changes and exit.
7 Remove the 3Com Software driver diskette and reboot the machine.
8 When Windows 95 restarts a message will appear that new hardware has
9 Insert 3Com Etherlink 3C900 software disk 1 of 2 ver 2.1.
10 Click "Next" to begin hardware wizard on the "Update Device Driver
Driver Name: El90X.DOS Size: 45KB Date: 3/21/97
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
card into an PCI slot.
Drivers Ver. 2.1." and execute "A:\3C90XCFG.EXE."
under the heading "Device Configuration."
been found.
Wizard" dialog message.
3 Connecting to a Windows NT Server 3.51
Normal
Auto Select (N-WAY)
Disabled
Auto Select (N-WAY)
FCC0h (PCI)
9 (PCI)
Windows 95 SR2