HP Vectra VL6 6 Installation Manual page 31

Windows NT Requirements
Workstation
• HP Vectra with Microsoft Windows NT Workstation 3.51 installed.
Version 3.51
• 3COM Etherlink 3C900 ethernet card and drivers disk ver. 2.1.
• Microsoft Windows NT Workstation 3.51 and Service Pack Media.
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
• I/O Base Address
• Interrupt Request Level
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink 3C900 adapter
2 Connect network cable media to the 3COM 3C900 card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM Software "3C900 Ethernet drivers disk
5 Select "CONFIGURE NIC" and verify the resource settings listed above
6 If changes are required, save those changes and exit.
7 Remove the 3Com Software driver diskette and reboot the machine.
8 After windows loads, log onto the machine with administrator privileges.
9 Open the "Main" Program Group and double-click on "Control Panel"
Driver Name: OMESETUP.INF Size: 41KB Date: 3/14/97
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
card into a PCI slot.
ver. 2.1" and execute "A:\3C90XCFG.EXE."
under the heading "Device Configuration."
(If you do not have the required information, contact your network
administrator)
Icon.
4 Connecting to a Windows NT Server 4.0
Windows NT Workstation Version 3.51
Normal
Auto Select (N-WAY)
Disabled
Auto Select (N-WAY)
FCC0h (PCI)
9 (PCI)