HP Vectra VL6 6 Installation Manual page 35

Windows NT Requirements
Workstation 4.0
• HP Vectra with Windows NT Workstation 4.0 Service Pack 3.
• 3COM Etherlink 3C900 Ethernet card and drivers disk ver 2.1.
• Driver Name: 3C90X.INF Size: 71KB Date: 11/25/96
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
• I/O Base Address
• Interrupt Request Level
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink 3C900 PCI
2 Connect network media to the 3COM 3C900 PCI card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM Etherlink 3C900 Ethernet card and drivers
5 Select "CONFIGURE NIC," and verify the resource settings listed above
6 If changes are required, save those changes and exit.
7 Remove the 3com cards driver diskette and reboot the machine.
8 Power on the machine and allow it to boot to Windows NT Workstation
Microsoft Windows NT Workstation 4.0 and Service Pack Media.
(If you have a Hewlett-Packard pre-loaded HDD, the media is
located at "C:\I386")
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
adapter card into a PCI slot.
Disk 1 Ver. 2.1. and execute "A:\3C90XCFG.EXE."
under the heading "Device Configuration."
4.0.
4 Connecting to a Windows NT Server 4.0
Windows NT Workstation 4.0
Normal
Auto Select (N-WAY)
Disabled
Auto Select (N-WAY)
FCC0h (PCI)
9 (PCI)