HP Vectra VL6 6 Installation Manual page 9

Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2 installed.
• 3COM Etherlink 3C900 Ethernet card and drivers disk ver 2.1.
• File Name: OEMSETUP.INF Size: 41KB Date: 3/14/97
• Windows 95 SR2 media. (If you have an HP preloaded HDD, the media is
• Novell Netware 4.11 server that supports Net BEUI, NWLink IPX/SPX,
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
• I/O Base Address
• Interrupt Request Level
Procedure
1 With the HP Vectra turned off install the 3COM Etherlink III 3C900
2 Power on the machine and restart Windows 95 SR2 in MS-DOS Mode.
3 Insert the 3COM drivers diskette (ver. 2.1 downloaded from 3COM's
4 Select "CONFIGURE NIC," and verify the resource settings listed above
5 If changes are required, save those changes and exit.
6 Remove the 3com cards driver diskette and restart the machine.
7 Windows 95 SR2 should automatically recognize the 3COM 3C900
8 With "PCI Ethernet Controller" listed, click on "Next."
9 Click on "Other Locations" and insert the 3C900 driver's disk 1 of 2.
located at C:\Masters\Win95\System\Cabs\)
and NWLink NetBIOS transfer protocols.
adapter card into a PCI slot.
website) and execute 3C90XCFG.EXE.
under the heading "Device Configuration."
ethernet card.
2 Connecting to a Netware 4.11 Server
Normal
Disabled
Disabled
10BASE-T
FCC0h (PCI)
9 (PCI)
Windows 95 SR2