HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual page 14

Chapter 1
Connecting External SCSI Devices
Connect external Ultra3 SCSI devices to the 68-pin external LVD/SE SCSI
connector. Each external device will require a high density 68-pin external LVD
SCSI cable.
Follow these steps to connect the external devices:
1. Connect one end of the external LVD SCSI cable to the external LVD/SE
connector on the HP Ultra3 SCSI host bus adapter.
Figure 1-7. Connecting External SCSI Devices
2. Connect the other end of the external SCSI cable to a SCSI connector on the
back of an external SCSI device. If you are installing only one external device,
terminate the device and skip to
3. Connect other external devices by cabling each device to the previous one, as
shown below.
8
Step 4.
Installation and Setup