Novell Netware Installation; Installing The Driver When Installing Netware; Netware 3.12/3.2 - HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual

5 Novell NetWare Installation

This chapter explains how to install the HP Ultra3 Family Manager Set driver <File
Name>adpt160m.ham for Novell NetWare— NetWare 3.3, 4.2, and 5.0.
If you are performing a first time NetWare installation, see "Installing the Driver
When Installing NetWare" in the next section. If NetWare is already installed in
your system, see
page 46.

Installing the Driver When Installing NetWare

To install the <File Name>adpt160m.ham driver when you install NetWare, follow
the instructions below for the version of NetWare you are installing.

NetWare 3.12/3.2

Follow these instructions only if you are installing NetWare 3.12/3.2 for the first
time:
1. To complete the NetWare 3.12/3.2 installation, you must go to the Novell Web
site at:
http://developer.novell.com/devres/sas/certinfo.htm
and then download the nwpa_up.exe update patch from the link at the message:
Download the NWPA Update Package
2. Create the DOS partition on the boot hard disk drive.
3. If you are installing NetWare 3.12/3.2 from a CD-ROM attached to an HP Ultra3
host adapter, follow the instructions in
Bootable Hard Disk"
access.
If you are installing NetWare 3.12/3.2 from a CD-ROM attached to a host
adapter other than an HP Ultra3 host adapter, refer to your CD-ROM or
computer documentation for instructions on configuring your computer for
CD-ROM access.
4. Reboot your computer after configuring for CD-ROM access.
"Installing the Driver When NetWare is Already Installed"
on page 45 to configure your computer for CD-ROM
"Install CD-ROM Drivers on a DOS
on
41