HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual page 62

Chapter 5
[xxxxx0ab] Driver already loaded for this host bus adapter
The driver is already loaded for this adapter. Verify that the correct adapter is
specified in your command line or startup file.
[xxxxx0ac] Driver already loaded for all host bus adapters
The driver is already loaded for all the supported adapters in this system.
[xxxxx0a4] SCSI bus reset by third party hardware
Hardware such as an array enclosure may have reset the SCSI bus. This is a normal
condition unless you receive additional errors.
[xxxxx0a7] Unable to allocate memory
[xxxxx0a8] Unable to allocate memory
This indicates that there may be a problem with the amount of memory installed in
your system. Verify that your system has at least the minimum amount of memory
required by your operating system.
[xxxxx0a9] Possible interrupt conflict
This indicates that the adapter IRQ conflicts with the IRQ of another board installed
in your system. Check your hardware documentation for instructions on setting and
changing IRQs.
[xxxxx0c9] Invalid command line parameter
A command line option for the driver is invalid. See
Line Options"
[xxxxx0ca] Invalid command line syntax
[xxxxx0cb] Invalid command line syntax
[xxxxx0cc] Invalid command line syntax
The command line syntax for the driver is incorrect. See
Line Options"
[xxxxx07c] Unable to allocate memory
[xxxxx07d] Unable to allocate memory
[xxxxx07e] Unable to allocate memory
56
on page 47 for valid command line options.
on page 47 for entering the correct syntax.
Novell NetWare Installation
"Using the Load Command
"Using the Load Command