HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual page 34

Chapter 3
[xxxxx004] Command completed with error
[xxxxx005] Command completed with error
[xxxxx006] Command completed with error
A request issued to a target device completed with indication that there is an error.
In most cases, the error is recovered and normal operations continues.
[xxxxx010] Error issuing command
An error has occurred while the driver was setting up its internal data structures.
[xxxxx011] Error issuing command
The requested command is not supported by this driver.
[xxxxx012] Error issuing command
[xxxxxx99] Error issuing command
The driver does not recognize the target device.
[xxxxx021] Target device protocol error
An unexpected event occurred during data transfer between the adapter and target
device. Normally, this indicates a faulty or non-compliant target device.
[xxxxx022] Adapter or target device protocol error
The adapter or target device has broken the communication protocol. A badly
behaving device could cause this message to appear. Normally this is not a serious
problem. If you get this message frequently over a short period of time, it could
indicate that the device or system is malfunctioning. Unplug or power down unused
devices to see if the problem persists.
[xxxxx023] Target device parity error
The driver has detected a parity error by the target device.
[xxxxx024] Data overrun or underrun
The adapter was given more or less data than the expected amount of data.
[xxxxx031] Target device queue full
The target device internal buffer is full.
28
Microsoft Windows NT Installation