Completing A Fresh Windows Nt 4.0 Installation From Cd-Rom; Installing The Driver When Windows Nt Is Already Installed; Updating Windows Nt 4.0 - HP Tc2110 - Server - 128 MB RAM Installation And Configuration Manual

Chapter 3

Completing a Fresh Windows NT 4.0 Installation From CD-ROM

1. Insert the Windows NT 4.0 CD into the CD-ROM drive.
2. Start your system. Press the F6 key when you see the following message:
"Setup is inspecting your computer's hardware
configuration..."
3. If you do not see this message, your system may not be setup to boot from a CD-
ROM. You will need to install from floppy disks. See
Windows NT 4.0 Installation From Floppy Disk"
4. When prompted, press S to specify an additional device.
5. Press Enter to select Others; insert the HP Ultra3 Family Manager Set disk for
Windows NT into your floppy disk drive.
6. Using the arrow keys, select the following driver and press Enter:
Adaptec Ultra3 PCI SCSI Controller (NT4.0)
7. To add other host adapters, press S and repeat from
adapter and insert the appropriate driver disk.
8. Press Enter to continue with the Windows NT operating system setup. Follow
the instructions on-screen and in the Windows NT documentation to complete
the installation.
Installing the Driver When Windows NT is
Already Installed
To update or install the <File Name>adpu160m.sys driver if Windows NT 4.0 is
already installed, follow the instructions below.

Updating Windows NT 4.0

1. Start Windows NT.
2. Click the Start button on the Windows NT task bar, and then point to Settings.
3. Click the Control Panel.
4. Double-click the SCSI Adapters icon.
5. Click the Drivers tab, and then click the Add button.
6. In the Install Driver window, click the Have Disk button.
20
Microsoft Windows NT Installation
"Completing a Fresh
on page 19.
Step 4 for each additional