Diskette Drive (Optional); Removing A Diskette Drive - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

2. Install the four black metric M3 guide screws into the drive (1).
Figure 5-44
3. Align the screws with the grooves in the drive bay and gently slide the drive into the casing until it
snaps into place (2).
CAUTION:
to see if it can become disengaged. Failure to properly secure the drive can cause damage to the
drive when moving the workstation.
4. Connect the power and drive cables to the drive and system board.
NOTE:
SATA Configuration Mode for this workstations is set to:
IDE Mode—Only SATA ports 0 and 2 are functional for any SATA devices.
AHCI Mode—All SATA ports are functional for any SATA devices.
RAID + AHCI Mode—You will not be able to update system BIOS from the SATA optical drive.

Diskette drive (optional)

This section describes how to remove and install a diskette drive.

Removing a diskette drive

1. Disconnect power from the system
access panel
(Removing the front bezel on page
92 Chapter 5 Removal and replacement procedures
Installing the optical drive
Ensure that the optical drive is secure in the workstation chassis by pulling the drive
SATA optical drives can be configured in a workstation with SATA hard drives. When the
(Removing the side access panel on page
(Predisassembly procedures on page
61), and then remove the front bezel
65).
57), remove the side
ENWW