Pci Express Cards; Removing A Pci Express Card - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

2. Align the rear bracket with the holes in the rear of the chassis (1), and then rotate the bracket down
into position (2).
Figure 5-27
3. Secure the bracket to the chassis with two screws (3).

PCI Express cards

PCI Express improves system attributes and enables a low-power, scalable, high-bandwidth
communication path using a small number of connections, or wires, compared to traditional parallel
interfaces such as PCI. The PCI Express I/O slots can support other PCI Express cards with less bus
bandwidth than what is physically defined for the slot. Use the following table to determine PCI Express
card compatibility.
Table 5-7
PCI Express x1 slot
PCI Express x8 (x4) slot
PCI Express x16 slot

Removing a PCI Express card

To remove a PCI Express card:
1. Disconnect power from the system
access panel
installed
78 Chapter 5 Removal and replacement procedures
Installing a PCI card support bracket
PCI Express compatibility matrix for the HP xw4600 Workstation
Slot type Mechanical compatibility
x1 cards
x1, x4, and x8
x1, x4, x8 and x16 cards
(Removing the side access panel on page
(PCI card support bracket on page
Electrical compatibility
x1 modes
x1 and x4 modes
x1, x4, x8, and x16 modes
(Predisassembly procedures on page
61), and then remove the PCI retainer, if
76).
57), remove the side
ENWW