Installing The System Board; Product Recycling - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

4. Press the release tab as shown in the following illustration (1).
Figure 5-63
5. Slide the system board toward the front of the chassis and then lift it out of the workstation (2).

Installing the system board

To install the system board:
1. Set the system board in the chassis, slightly away from the rear of the chassis. The mounting hooks
will seat in the recesses of the tray so that the tray lies flat on the chassis base.
2. Slide the tray towards the rear of the chassis until the heat sink mounting holes are aligned.
3. Reinstall the processor heatsink, cards, and cables.

Product recycling

HP encourages customers to recycle used electronic hardware, HP original print cartridges, and
rechargeable batteries.
For information about recycling HP components or products, see http://www.hp.com/go/recycle.
106 Chapter 5 Removal and replacement procedures
Removing the system board
ENWW