Using The Computer Setup (F10) Utility To Reset Cmos - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

NOTE:
does not clear CMOS if the power cord is connected.
NOTE:
System board components on page
5. Replace the access panel.
6. Reconnect any external devices.
7. Plug in and power on the workstation.
The workstation powers up for three to five seconds, then powers down.

Using the Computer Setup (F10) Utility to Reset CMOS

1. Access the Computer Setup (F10) Utility menu. When the Computer Setup message appears in
the lower-right corner of the screen, press F10. Press Enter to bypass the title screen, if necessary.
NOTE:
powered off, then on again, to access the utility.
2. From the Computer Setup (F10) Utility menu, select File>Set Defaults, and then select Exit. This
restores the settings that include boot sequence order and other factory settings. However, it does
not force hardware rediscovery.
ENWW
Be sure that the AC power cord is disconnected from the power outlet. The CMOS button
For assistance locating the CMOS button and other system board components, see
If you do not press the F10
57.
key while the message is displayed, the workstation must be
Clearing and Resetting the CMOS 157