Hood Sensor (Smart Cover Sensor) (Optional); Removing The Hood Sensor; Smart Cover Lock Solenoid (Optional); Removing The Smart Cover Lock Solenoid - HP Xw4600 - Workstation - 2 GB RAM Technical Reference Manual

Hood Sensor (Smart Cover Sensor) (optional)

This section describes how to remove the Hood Sensor.

Removing the Hood Sensor

To remove the Hood Sensor:
1. Disconnect power from the system
access panel
2. Disconnect the Hood Sensor connector from system board (1).
Figure 5-9
3. Slide the Hood Sensor forward, push it down, and then remove it from the chassis (2).
NOTE: To replace the Hood Sensor, reverse the previous steps.

Smart Cover Lock solenoid (optional)

This section describes how to remove the Smart Cover Lock solenoid

Removing the Smart Cover Lock solenoid

To remove the Smart Cover Lock solenoid:
NOTE: To purchase a FailSafe key, contact your authorized HP reseller or service provider, or see
the HP Web site for ordering information.
1. Disconnect power from the system
access panel
ENWW
(Predisassembly procedures on page
(Removing the side access panel on page
Removing the Hood Sensor
(Predisassembly procedures on page
(Removing the side access panel on page
57) and remove the side
61).
57) and remove the side
61).
Removing and replacing components 63