Installing A Sata Hard Drive - HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual

4. Lift the green drive-lock release tab (1) and slide the hard drive out of the chassis (2), as shown:
Figure 4-49
5. As shown in the following figure, remove the hard drive body from the drive mounting rails and
retain the rails for later use.
Figure 4-50

Installing a SATA hard drive

NOTE: Each workstation hard drive bay can be configured at the factory to hold three small form factor
hard drives instead of two standard size drives. To obtain the option kit documentation for removal and
replacement of small form factor hard drives, refer to the HP xw Workstation series - Small form factor
bay converter and hard drive installation user guide at:
92 Chapter 4 Removal and replacement procedures
Removing the SATA hard drive
Removing the hard drive body from the hard drive mounting rails
http://www.hp.com/support/xw6600 manuals
ENWW