HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual page 143

Table 5-18 POST error messages (continued)
Screen message
923—Non fatal uncorrectable
PCI error in slot #
924—Non fatal correctable
PCI error
925—Non fatal uncorrectable
ESI error
926—Non fatal correctable
ESI error
927—Non fatal FSB error
928—Non fatal uncorrectable
FBD error
929–Non fatal correctable
FBD error
930–Non fatal internal
Northbridge error
1720—SMART Hard Drive
Detect Imminent Failure
1783—Fixed Disk 0/1 locked
1794—Inaccessible devices
attached to SATA 1 and/or
SATA 3
1796—SATA Cabling Error
1800—Temperature Alert
1801—Microcode Patch Error
1802—Processor Not
Supported
ERROR: An unsupported
processor is installed. System
halted
ERROR: A processor requiring
too much power is installed.
System halted
ERROR: Mixing processors
with different power
requirements. This is not
supported. System halted.
ENWW
Probable cause
A PCI or PCIe non-fatal error condition
occurred for the card in the designated
slot
Non-fatal, uncorrectable ESI error on
slot # occured.
Non-fatal, correctable ESI error on slot
# occured.
Non-fatal FSB error on FSB # occured. Contact HP support.
Non-fatal, uncorrectable FBD error on
DIMM # occurred.
Non-fatal, correctable FBD error on
(DIMM is identified)
Non-fatal, Internal Northbridge error
Hard drive is about to fail. (Some hard
drives have a firmware patch that fixes
erroneous error messages.)
Hard disk drive failure
Missing or improperly attached cable
Missing or improperly attached cable
Insufficient coolling
Processor not supported by ROM
BIOS
The system board does not support the
processor
Unsupported processor detected
Unsupported processor detected
Mixed type processors detected
Recommended action
Move the card to a different slot. If the problem persists,
replace the card.
Contact HP support.
Contact HP support.
Contact HP support.
Contact HP support.
Contact HP support.
Contact HP support.
1. Determine if hard drive is giving correct error
message.
2. Run the Drive Protection System test (if
applicable).
3. Apply firmware patch (if applicable).
See http://www.hp.com/support.
4. Back up contents and replace the hard drive.
Diagnose the hard drive, and replace it if necessary.
Ensure that a cable is attached. Reattach the cable.
Ensure that a cable is attached. Reattach the cable.
Ensure proper fan operation, and increase fan speed.
Ensure that the installed processor is supported by the
workstation. Upgrade BIOS to proper version for this
workstation and processor.
Replace the processor with a compatible one.
Replace the processor.
Replace the processor.
Replace the processors with matched processors.
POST error messages 133