Installing a diskette drive
To install a diskette drive:
1.
Disconnect power from the workstation (see
2.
Remove the side access panel (see
3.
Remove the front bezel (see
4.
If present, remove the diskette bay blank from the front bezel.
5.
Remove the EMI filler from the diskette bay.
6.
Slide the diskette drive into the bay until it locks solidly into place.
7.
Connect the diskette drive power and data cables.
8.
Reinstall the front bezel and side access panel.
9.
Connect power to the workstation.
System speaker
This section describes how to remove and reinstall or replace the system speaker.
Removing the system speaker
To remove the system speaker:
1.
Disconnect power from the system (see
2.
Remove the side access panel (see
3.
To provide access to the speaker, remove the optional front chassis PCI card guide and fan, if
installed.
4.
Detach the speaker cable from the in-line control panel cable, if you have not already done so.
5.
Slide the speaker away from the three flanges and remove it from the chassis, as shown:
Figure 4-22
6.
To replace the speaker, reverse the previous steps.
ENWW
Removing the front bezel on page
Removing the workstation speaker
Predisassembly procedures on page
Side access panel on page
Predisassembly procedures on page
Side access panel on page
Removing and replacing components
52).
58).
61).
52).
58).
71