HP Xw6600 - Workstation - 2 GB RAM Technical Reference Manual page 97

To remove a SAS hard drive:
1. Disconnect power from the system (see
2. Remove the side access panel (see
CAUTION:
(ESD) precautions while performing the system parts removal and replacement procedures:
— Work on a static-free mat.
— Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your
body to the ground.
— Create a common ground for the equipment you are working on by connecting the static-free
mat, static strap, and peripheral units to that piece of equipment.
3. Disconnect the power (1) and data (2) cables from the hard drive, as shown:
Figure 4-41
ENWW
To prevent damage to the workstation, observe the following Electrostatic Discharge
Disconnecting the SAS hard drive cables
Predisassembly procedures on page
Side access panel on page
Removing and replacing components
52).
58).
87