HP D6030A - NetServer - E50 Installation Manual page 15

Chapter 2 Microsoft Windows 2000 Server and Advanced Server Installation Guide
4. Press Enter to continue at the "Windows 2000 Server Setup. Welcome to
Setup..." Screen.
5. Press F8 to accept the licensing agreement.
6. Press C to continue Setup at the "Setup has determined that your
computer's startup hard disk is new..."
7. At the drives partitioning screen, select the target drive. If you want to use
the entire drive to install Windows 2000 then press Enter. Otherwise, press
C to create a drive a partition.
In this example we will create a 2GB partition. Please note that Windows
2000 does not have the 2GB limitation present on NT 4.0
Press C to create a partition.
8. At the "Create partition size" prompt, type 2048 and press Enter.
9. It is recommended that you create all the partitions needed for each hard
drive present on your system.
10. Select the target drive to be used to install Windows 2000. Press Enter.
11. Select "Format the partition using the NTFS file system" and press enter.
12. The installer will format and copy files to the hard drive. The system will
reboot
13. At the Installation Wizard first dialog box, click Next to continue.
14. The "Installing Devices" screen will be shown with a progress bar on the
display. This may take 10 to 15 minutes.
15. Click Next at the regional Settings screen.
16. At the "Personalize Your Software" screen type the following:
Name: ...
Organization: ...
Click Next.
17. Click the Per Seat radio button.
18. Click Next.
19. At the "Computer Name and Administrator Password" type the following
information:
Computer Name: ...
Administrator password: ...
Confirm password: ...
Click Next.
20. Click Next at the Windows 2000 Component screen.
11