Microsoft Windows Nt 4.0 Server Installation Guide For The Hp Netserver E 200; Section 1. Hardware Requirements For Installation; Section 2. Create The E 200 Drivers Diskettes; Section 3. Create Microsoft Windows Nt Installation Diskettes - HP D6030A - NetServer - E50 Installation Manual

1 Microsoft Windows NT 4.0 Server
Installation Guide for the HP
NetServer E 200
This section was created January 28, 2000.

Section 1. Hardware Requirements for Installation

Prepare your NetServer following the instructions in the E 200 Installation Guide.
It is recommended that you do not install any third party adapters until you verify
that the Hewlett-Packard equipment is functioning properly and you complete the
Windows NT installation.
To avoid problems use only hardware that appears on the Windows NT Hardware
Compatibility List. (HCL) You can access the latest HCL via Microsoft's Web site
at
http://www.microsoft.com/ntworkstation/

Section 2. Create the E 200 Drivers Diskettes

Your system includes an HP Startup CD. Boot your system from the CD and
follow the on-screen instructions to create two Windows NT 4.0 Drivers Diskettes
and two HP Diagtools Diskettes.
Drivers Diskette #1 – SCSI and LAN drivers
A:\SCSI – Drivers for HP SCSI card
A:\NICDRV –Drivers for HP LAN card
Drivers Diskette #2 – High resolution video drivers
A:\VIDEO – Drivers for HP video card
Section 3. Create Microsoft Windows NT
Installation Diskettes
Three installation diskettes are required to install Microsoft Windows NT 4.0 on
your server. Follow these steps to create these installation diskettes:
1. Locate three blank, formatted 3.5" diskettes.
1