Section 4. Perform Manual Windows Nt Installation - HP D6030A - NetServer - E50 Installation Manual

Chapter 1
2. Insert your Microsoft Windows NT 4.0 CD-ROM into a desktop PC.
3. From a DOS prompt, type: CD-ROM:\i386\winnt32 /ox
4. Follow the prompt and insert the diskettes in the order described.
Section 4. Perform Manual Windows NT
Installation
The installation of Windows NT contains five phases.
Phase 0 – Run Diagnostics (Optional)
Phase 1 – Driver Installation
Phase 2 – Hard Drive Preparation
Phase 3 – System Configuration Details
Phase 4 – Completing the Installation
NOTE Do not try to install Windows NT 4.0 via booting from the
Windows NT CD-ROM. This method of installation does not
work properly. The installation procedure will prompt you to
insert the Windows NT CD-ROM at a later time.
PHASE 0 – Run Diagnostics (Optional)
Once the E 200 hardware is installed, boot the system from the DiagTools
Diskette that was created from the HP Startup CD to run the hardware diagnostic
and to save/view the hardware inventory.
PHASE 1 – Driver Installation
1. Insert the Windows NT Setup/Boot Diskette #1 and boot the system.
2. Replace the diskette when prompted and press Enter.
3. Press Enter at the first menu to setup Windows NT.
4. If the system has a SCSI HDD :
Press S to "Skip mass storage detection and manually select SCSI
adapters"
Press S again to "Specify additional SCSI adapters".
The Windows NT installer will display a scrolling list of options.
2
Microsoft Windows NT 4.0 Server Installation Guide