Red Hat Linux 6.1 Installation Guide For The Hp Netserver E 200; Section 1. Hardware Requirements For Installation; Section 2. Hp E 200 Netserver Diskette; Section 3. Perform Manual Linux 6.1 Installation - HP D6030A - NetServer - E50 Installation Manual

Network operating system

Hide thumbs Also See for D6030A - NetServer - E50:

Table of Contents

6 Red Hat Linux 6.1 Installation Guide

for the HP NetServer E 200

This section created January 19, 2000.

Prepare your NetServer following the instructions in the E 200 Installation Guide.

It is recommended that you do not install any third party adapter until you verify

that the Hewlett-Packard equipment is functioning properly and you complete the

Red Hat Linux installation.

Your system includes a Startup CD. Boot your system from the CD and follow the

on-screen instructions to create two HP Diagtools Diskettes .

The manual installation of Red Hat Linux contains two phases.

Phase 0 – Run Diagnostics (Optional)

Phase 1 – OS Installation

PHASE 0 – Run Diagnostics (Optional)

Once the NetServer hardware is installed, boot the system from the DiagTools

Diskette that was created from the Startup CD to run the hardware diagnostic and

to save/view the hardware inventory.

PHASE 1 – OS Installation

1. Insert Red Hat Linux 6.1 bootable CD-ROM. Press the Enter key to begin

the installation.

2. At "Language Selection", select English. Select Next.

3. At "Keyboard Configuration":

Model: Generic 104-Key PC

Layout: US English.

Table of Contents