HP D6030A - NetServer - E50 Installation Manual page 29

Network operating system
Hide thumbs Also See for D6030A - NetServer - E50:
Table of Contents

Advertisement

Chapter 5
4. HP recommends accepting the default 100MB boot partition by selecting
Continue. Your system will now create the partition, reboot, and format
that partition.
5. Choose Continue when prompted with: 'A new server.'
6. Modify or accept the default country, code page, keyboard, mouse and
video settings.
7. Now the installation program will detect hardware and attempt to match
the drivers to the hardware. You will see a driver summary screen. Under
"Hot plug support module" verify it displays "optional" because Hot Plug
PCI is not supported on this HP NetServer. Under the "Options" menu,
choose Modify and press Enter.
8. Highlight the Storage Adapters item and press Enter.
9. IDEATA, AHA2940.HAM, AHA2950.HAM will be listed as drivers.
Highlight each AHA2940.HAM driver and delete them by pressing the
Delete key on your keyboard. The only remaining driver should be the
IDEATA.HAM driver. You will now supply your own AHA2940 drivers
from the HP supplied drivers diskette.
10. Insert the HP NetServer E 200 drivers diskette in the floppy drive. Press
the Insert key on your keyboard to add a driver.
11. Press the Insert key again to add a driver which is not listed.
12. Press F3 and specify the path: A:\SCSI and press enter. This process will
take a few seconds to process.
13. The installation program will detect the PCI SCSI hardware and it will add
the AHA2940.HAM driver from the drivers diskette.
14. To edit the drivers listed under Network boards, select "Return to
driver summary". Press Continue to leave the storage adapters driver
setup.
15. From the Drivers Summary screen, choose Modify and highlight the
"HPTX" and "CHPTX" driver which was auto-detected by the installation
program. Delete this driver by pressing the Delete key.
16. Insert the HP NetServer E 200 NetWare drivers diskette. Press the Insert
key.
17. Press the Insert key again to add a driver not listed.
18. Press F3 and specify the path: A:\nicdrv
19. Choose "CHPTX.LAN" and press enter.
Novell NetWare Small Business 5.0 Installation Guide
25

Advertisement

Table of Contents
loading

Table of Contents