Event Memory Operation; Registering The Current Settings And Created Effects As Events; Calling Events; Clearing Event Memory - Panasonic AG-HMX100 Operating Instructions Manual

Event Memory Operation

The EVENT SET and EVENT RECALL buttons are used to
register and call events, respectively.
The currently selected event number is shown in the event
number display area of the setting screen. [E] is shown for
a null event.
EVENT
00
E
Registering the Current Settings
and Created Effects as Events
1
Press the EVENT SET button.
The button is lighted.
2
Select the event number in the range of 0 to 99.
Enter the number using the numeric keys or
increment or decrement the value using the +
or – key, respectively.
3
Press the key.
The EVENT SET button flashes for approximately 2
seconds, and then goes off.
To register a series of effects as events
Up to 10 effects can be consecutively registered as events
with numbers 50 to 59, 60 to 69, 70 to 79, 80 to 89, or 90 to
99.
Since those 10 events can be called and executed
consecutively, the key frame settings can also be
registered as events.

Calling Events

1
Press the EVENT RECALL button.
The button is lighted.
2
Select the event number. Enter the number
using the numeric keys or increment or
decrement the value using the + or – key,
respectively.
20
3
To call the settings, press the
The EVENT RECALL button goes off.
The selected event is called and the settings of the
setting screen are changed to those registered as
the event.
4
Press the AUTO TAKE button.
The effects registered as the event are executed.
If one of the events in which a series of
effects were registered is called
If 10 events are consecutively registered with event
numbers in the range of 50 to 59, 60 to 69, 70 to 79,
80 to 89, or 90 to 99, the settings of the first event are
reproduced when one of the 10 events is called.
 NOTE
When the event is called, the settings of the input source used
during creation of the effects are not reproduced. The effects
are executed with the currently available input source settings.
Thus, first reproduce the same input source settings as those
during effect creation, and then call the event to execute.

Clearing Event Memory

1
Press the EVENT RECALL button.
The button is lighted.
2
Select the event number. Enter the number
using the numeric keys or increment or
decrement the value using the + or – key,
respectively.
3
Press the key while holding down the SHIFT
key.
The EVENT RECALL button goes off.
The memory of the selected event is cleared.
key.