Setting 3D Mode [3D] - Panasonic AG-HMX100 Operating Instructions Manual

Setting 3D Mode [3D]

This function allows selection of 3D mode and 3D signal
format.
Select [3D] in the [SETUP] menu using the rotary 1 control,
and set the 3D mode and 3D signal format as described
below using the rotary 2 and 3 controls.
Rotary 1 Rotary 2 Rotary 3
3D MODE FORMAT
OFF 1080/59i
OFF 720/50p
MODE1 720/59p
MODE2 1080/23
MODE3-M 1080/50i
MODE3-S 1080/59i
To select 3D mode
Select 3D mode using the rotary 2 control.
When the current setting is changed, * is added to the
setting value.
If other menu screen is opened with * displayed, the setting
value returns to the previous value without being changed.
When the message [OK?] appears, press the
To cancel the selection, press the
down the SHIFT key.
Setting Mode
OFF Regular display mode
MODE1 2-channel switching, L and R outputs
MODE2 2-channel switching, Side By Side signal
output
MODE3-M 4-channel switching, L and R outputs,
master
MODE3-S 4-channel switching, L and R outputs, slave
Setting Screen in 3D Mode
If the 3D mode is set to other than [OFF], [3D] appears
in the Joystick, Rotary Z Control Settings, and 3D Display
Area.
The same content as in 2D mode is displayed in the area
upper than the menu display area, but not used for the
operation.
POS. X 128 Y 128
Z 196
3D
EVENT ME TIME
00 2:00
E F
VIDEO EFFECTS
MOSAIC
OFF
DEFOCUS LEVEL
OFF
MONO
OFF
Rotary 4 Rotary 5
key.
key while holding
FAN STOP
PATTERN INT
3044 WHT
CH A
SIZE
XY 0
0
 NOTE
If [MODE3-M] or [MODE3-S] is selected, the settings of video
input sources are fixed as follows: [SDI1] to source 1, [SDI2] to
source 2, [SDI3] to source 3, and [SDI4] to source 4.
The [AUDIO VIDEO] submenu of the [SETUP] menu does not
show any [INPUT] items ( page Vol.1-24).
To select the 3D signal format
When the selected 3D mode is other than [OFF], set
[FORMAT] using the rotary 3 control.
When the selected 3D mode is [OFF], the system format
set in the [VIDEO FORMAT] submenu ( page Vol.1-26)
becomes effective.
 NOTE
• If [MODE3-M] or [MODE3-S] is selected, [1080/23] is not
displayed under the [FORMAT] item, and cannot be selected.
• If 3D mode and 3D signal format are changed, the system
must be restarted.
When the message "TURN POWER OFF" appears, turn off
the power and restart the unit.
25