Setting [Rs-232C] - Panasonic AG-HMX100 Operating Instructions Manual

TALLY connector
Open collector output connector for the tally lamp. When
video of input source 1, 2, 3, 4, 5, 6, 7 or 8 is being used,
the tally signal is output.
5 4
9 8
Pin No. Signal
1 Input source 1
2 Input source 2
3 Input source 3
4 Input source 4
5 Input source 5
6 Input source 6
7 Input source 7
8 Input source 8
9 GND
AG-HMX100P/HMX100E
Tally output
(Max. 50 mA)
GND
Tally connection example
The Tally signal is output with max. 35 V and max. 50 mA.

Setting [RS-232C]

This section describes the settings required for operating
this unit from an external controller via the RS-232C
interface.
The RS-232C interface is also used to operate a projector
from this unit.
Rotary 1 Rotary 2 Rotary 3
RS-232C B. RATE DATA L.
38.4k
9.6k 8BITS
19.2k 7BITS
38.4k
115.2k
3 2 1
7 6
Max. 35 V
Talley LED
Rotary 4 Rotary 5
PARITY
8BITS NONE PJ
NONE PJ
ODD RS-232C
EVEN
To set the communication rate
Set [B. RATE] using the rotary 2 control.
The following speeds can be selected.
Setting
[9.6 k]
[19.2 k]
[38.4 k]
[115.2 k]
The factory default setting is [9.6 k].
To set the data length
Set [DATA L.] to [8BITS] or [7BITS] using the rotary 3
control.
The factory default setting is [8BITS].
To set the communication parity
Set [PARITY] to [NONE] (not set), [ODD] (odd bit), or
[EVEN] (even bit) using the rotary 4 control.
To select the communication mode
[PJ] (projector) and [RS-232C] can be selected with the
rotary 5 control.
If [PJ] is selected, the Projector Setting screen appears
when the PROJECTOR/REMOTE button is set to ON,
enabling operation of a Panasonic projector from this unit.
Projector setting screen
The status of the projector connected to this unit is
displayed.
POS. X 128 Y 128
Z 512
EVENT ME TIME
00 02:00
E F
PROJECTOR ***
POWER : OFF
SHUTTER : OFF
POWER SHUTTER
OFF
Appears during projector monitoring.
When the projector is not compatible with the
communication system of this unit or the unit cannot obtain
any information due to differences in the communication
protocol, "---" appears for [POWER] and [SHUTTER].
In addition, "---" appears for [SHUTTER] when the projector
power is off.
Baud Rate
9600 bps
19200 bps
38400 bps
115200 bps
PATTERN INT
0056 WHT
OFF
29