English; Projecting; Selecting The Input Signal; How To Adjust The Focus, Zoom And Shift - Panasonic PT-DW530E Operating Instructions Manual

Projecting

Check the connections of the peripheral devices, installation of the projection lens (
Æ
of the power cord ( page 32) and switch on the power (
and adjust the image.

Selecting the input signal

Select an input signal.
The image selected with <INPUT SELECT> button is
projected. ( Æ page 37)
Attention
Images may not be projected properly depending on the
z
connected device and DVD, video tape, etc. to be played.
Select a system format that is suitable for the input signal
using the [SYSTEM SELECTOR] in the [PICTURE] menu
Æ
( page 47).
Check the aspect ratios of the screen and the image and
z
select the optimum aspect ratio using [ASPECT] in the
Æ
[PICTURE] menu ( page 48).
Æ
page 33) to start the projector. Select the input signal
How to adjust the focus,
zoom and shift
1 ) Adjust the projected image with the
lens shift lever.
See "Lens shift and positioning" on page 36.
Lens shift lever
2) Adjust the focus and the projected
image size.
Turn the focus lever and zoom
J
lever to adjust the image.
You can confirm the adjusted
J
effect with the TEST PATTERN
in OPTION menu. See "TEST
PATTERN" on page 71.
Note
Do not touch the air exhaust port as this may cause
z
burns or injury.
If keystone distortion occurs, see
z
50.
If you adjust the focus, you may need to adjust the size
z
of the image by moving the zoom lever again.
It is recommended that the images are projected
z
continuously for at least 30 minutes before the focus is
adjusted.
Æ
page 29), and connection
Zoom ring
Focus ring
"KEYSTONE" on page

ENGLISH -

35