Waveform Monitor; (Pt-Dz570E Only); Auto Signal - Panasonic PT-DW530E Operating Instructions Manual

DISPLAY OPTION menu

WAVEFORM MONITOR

(PT-DZ570E only)

This function displays the waveform of the input signal
from a connected peripheral device.
You can check if the image output (BRIGHTNESS)
signal level is within the range recommended by this
projector and adjust it as necessary.
1 ) Press ▲▼ to select [WAVEFORM
MONITOR].
2 ) Press ◄► to switch [WAVEFORM
MONITOR].
The setting will change as follows each time
z
◄► is pressed.
OFF
3 ) Press the <MENU> button twice to turn
off the menu screen.
4 ) Select any horizontal line with the ▲▼.
Line selection
(BRIGHTNRSS)
Line selection
(BLUE)
Note
Setting can also be performed using the <FUNCTION>
z
button. ( Æ page 67)
Adjust the waveform
J
Project the brightness adjustment signal from, for
example, a commercially available adjustment disc
(0% [0 IRE or 7.5 IRE] - 100 % [100 IRE]) and adjust
the waveform.
100%
50%
0%
Adjusting brightness
Q
1 ) Select [Line selection (BRIGHTNRSS)]
in the waveform monitor.
2 ) Adjust the black level.
In [BRIGHTNESS] of on-screen menu
z
[PICTURE], adjust the 0 % of the black level of
the image signal to the position corresponding
to 0% on the waveform monitor.
56
- ENGLISH
ON
Line selection
(RED)
Line selection
(GREEN)
Monitor position
3 ) Adjust the white level.
In [CONTRAST] of on-screen menu [PICTURE],
z
adjust the 100 % of the while level of the image
signal to the position corresponding to 100 %
on the waveform monitor.
Adjusting RED, GREEN, and BLUE
Q
1 ) Set [COLOR TEMPERATURE] to
[USER1] or [USER2]. (
2 ) Select [Line selection (RED)] in the

waveform monitor.

3 ) Adjust the dark portion of RED.
In [RED] of [WHITE BALANCE LOW], adjust
z
the 0 % of the black level of the image signal
to the position corresponding to 0 % on the
waveform monitor. (
4 ) Adjust the light portion of RED.
In [RED] of [WHITE BALANCE HIGH], adjust
z
the 100 % of the white level of the image signal
to the position corresponding to 100 % on the
waveform monitor. (
5 ) Adjust [GREEN] and [BLUE] in a
similar manner.
Note
When the DVI-D signal or HDMI signal is inputted, check
z
that the [DVI SIGNAL LEVEL], [HDMI SIGNAL LEVEL],
and [HDMI SIGNAL LEVEL] are correctly set before
adjusting the black level.
The keystone cannot be applied to the waveform monitor
z
display.
The waveform monitor is not displayed while the on-
z
screen display is off.

AUTO SIGNAL

You can turn ON/OFF automatically detecting system
of the AUTO SETUP feature.
1 ) Press ▲▼ to select [AUTO SIGNAL].
2 ) Press ◄► to switch [AUTO SIGNAL].
The setting will change as follows each time
z
◄► is pressed.
Image
displayable
OFF
area
OFF
ON
Æ page 44)
Æ page 44)
Æ page 44)
ON
Only when <AUTO SETUP> button
is pressed, the projected image
position will be adjusted.
If unregistered signals are input
when [ON] is selected, auto setup
will be initiated automatically.