Monitor Lamp Indicators; Managing The Indicated Problems - Panasonic PT-DW530E Operating Instructions Manual

Monitor Lamp indicators

Managing the indicated problems

If a problem should occur with the projector, the indicators will inform you. Manage the indicated problems as
follow.
Attention
(STANDBY (R) / ON (G))
LAMP indicator
J
Lamp
indication
Indicates the time
Lighting in red for replacing the
lamp unit.
Blinking in red Lamp unit is not
(once) installed.
Blinking in red Error is detected
(3 times) in the lamp circuit.
Note
If no problem is found or the problem remains, do not turn on the projector. Instead contact your dealer.
z
If you set the [HIGH ALTITUDE MODE] to [OFF] and use the projector at an elevation higher than 1 400 meters above the
z
sea, the lamp service life will be shortened.
76
- ENGLISH
Power indicator
Information
Did you notice a "REPLACE
z
LAMP" message on the screen
when turning on the projector
power supply?
Check the lamp unit
z
compartment.
Did you turn the power back
z
on immediately after turning it
off?
Some error has arisen in the
z
lamp circuit.
Check for fluctuation (or drop)
z
in the source voltage.
Lamp indicator (LAMP)
Temperature indicator (TEMP)
Check point
z
z
z
z
z
z
Remedial measure
This lamp monitor lights up when the
lamp unit used hours have reached
1 800 hours (when [NORMAL] is
selected as the [LAMP POWER]
setting).
Request the dealer to replace the lamp
unit.
Install the lamp unit.
When lamp unit is installed and still
having the indicator lights, contact to
the dealer.
Wait until the lamp has cooled off, and
then turn on the power.
Turn off the MAIN POWER switch
using the procedure on page 34 and
consult the dealer.