Asus M2N-VM DH Manual page 39

2. IDE connectors (40-1 pin PRI_IDE)
The onboard IDE connector is for Ultra DMA 133/100/66 signal
cable(s). There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to the
motherboard's IDE connector, then select one of the following modes
to configure your device(s).
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
M2N-VM DH
M2N-VM DH IDE Connector
ASUS M2N-VM DH
Drive jumper
setting
Cable-Select or Master
Cable-Select
Master
Slave
PRI_IDE
R
Mode Cable
of device(s) connector
- Black
Master Black
Slave Gray
Master
Black or gray
Slave
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
1-29