Asus M2N-VM DH Manual page 44

10. JMicron
[black])
This connector is for a Serial ATA signal cable for a Serial ATA hard
disk drive that you can combine with an external Serial ATA 3.0 Gb/s
device to configure a RAID 0, and RAID 1 set through the onboard
Jmicron
on how to set up Serial ATA RAID configurations.
M2N-VM DH SATA RAID Connector
The JMicron
Set to [Raid] to use the connector to build a RAID set. See section
"2.4.5 Onboard Device Configuration" for details.
1-34
JMB363 Serial ATA connector (7-pin SATA_RAID1
®
JMB363 SATA RAID controller. Refer to Chapter 5 for details
®
M2N-VM DH
R
RAID Controller item in the BIOS is set to [IDE] by default.
®
SATA_RAID1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
Chapter 1: Product introduction