Department Code; Distinguish Thin Lines; Do Not Print Blank Pages - Toshiba e-STUDIO400P Printing Manual

4 PRINTING FROM UNIX/Linux

Department Code

The department code can be set using the following option.
Option Value Alternate Value
dept=code
A department code is specified within 63 characters.
If the entered department code is longer than 63 characters, it is clipped to 63 characters when a job is sent.
The following characters are invalid for department codes:
" & ' ( ) ; < > ^ ` | ~ @ # % * !
If your equipment is either the e-STUDIO6550C Series or the e-STUDIO4540C Series, enter the department code in a
5-digit number.
How the equipment performs printing for an invalid department code print job, for which an invalid department code
is specified, varies depending on the Invalid Department Code Print Job setting that can be set in the TopAccess
Administrator mode and whether SNMP communication is enabled or not.
- When SNMP communication is enabled and Invalid Department Code Print Job is set to [Store to invalid job
list], an error message will be displayed when an invalid department code is entered.
- When SNMP communication is disabled and Invalid Department Code Print Job is set to [Store to invalid job
list], the invalid department code print job will be stored in the invalid department code print job list without
printing.
- When the Invalid Department Code Print Job is set to [Print], the invalid department code print job will be
printed.
- When the Invalid Department Code Print Job is set to [Delete], the invalid department code print job will be
deleted.
For the appropriate department code, ask your system administrator.
Smoothing
This sets whether to print text and graphics smoothly. This mode can be set using the following option.
Option Value Alternate Value
smoothing=on ON
smoothing=off OFF
Example: The command to set the smoothing mode is "lp -o smoothing=on <filename>".

Distinguish Thin Lines

This sets whether to distinguish thin lines or not. This mode can be set using the following option.
Option Value Alternate Value
thinlinelimit=on ON
thinlinelimit=off OFF
Example: The command to set the thin line limit mode is "lp -o thinlinelimit=on <filename>".

Do Not Print Blank Pages

This sets whether or not a blank page is printed. This mode can be selected using the following option.
Option Value Alternate Value
blankpage=0
blankpage=1
Example: The command to set the blank page mode is "lp -o blankpage=0 <filename>".
168 Printing From Application
Description
Set the department code. A department code within 63
characters comes in [code].
Description
Set the smoothing mode.
Cancel the smoothing mode.
Description
Set the thin line limit mode.
Cancel the thin line limit mode.
Description
Set the blank page mode (disable Do not Print Blank
Pages).
Cancel the blank page mode (enable Do not Print Blank
Pages).