Configuring Pptp Servers - D-Link DWC-1000 User Manual

3. Click Save Settings.
Field
Enable PPTP Client
Server IP
Remote Network
Remote Netmask
Username
Password
Mppe Encryption
Idle Time Out

Configuring PPTP Servers

VPN Settings
Table 6-4. Fields on the PPTP CLIENT Page
PPTP Client Configuration
Enables or disables the PPTP client. Choices are:
Checked = enable PPTP client.
•
Unchecked = disable PPTP client.
•
PPTP Client Configuration
Enter the IP address of the PPTP server.
Enter the network address of the remote network that is local to the PPTP server.
Enter the subnetmask of the remote network which is local to the PPTP server.
Enter the username that the PPTP Client needs to connect to the PPTP server.
Enter the password that the PPTP Client needs to connect to the PPTP server.
Enables or disables the MPPE encryption client. MPPE is an encryption technology developed by
Microsoft to encrypt point-to-point links over a VPN tunnel. MPPE uses the RC4 algorithm with
either 40- or 128-bit keys. All keys are derived from the cleartext authentication password of the
user. RC4 is stream cipher; therefore, the sizes of the encrypted and decrypted frames are the
same size as the original frame. Choices are:
Checked = enable MPPE encryption.
•
Unchecked = disable MPPE encryption.
•
If there is no traffic from a user for more than the specified time-out, the connection is
disconnected.
DWC-1000 Wireless Controller User's Guide
Description
114