Where To Go From Here - D-Link DWC-1000 User Manual

To configure an interface for captive portal access, perform the basic configuration
procedure described in Chapter 3, and then use the procedure below to configure an
interface for captive portal access. You can associate a configured captive portal with a
specific physical interface or wireless network (SSID).
Step Configuration
1.
Create a captive portal.
a. Click Add.
b. Enter the name of a group and description.
c. Under User Type, check Captive Portal User.
d. Click Save Settings.
2.
Add captive portal users.
a. Click Add.
b. Enter a user name, first name, and last name.
c. Use Select Group to click the captive portal group
you created in step 1.
d. Enter a password.
e. Enter an idle timeout, in minutes.
f. Click Save Settings.
3.
Associate the captive portal group to an interface.
a. Select an interface in the Interface List.
b. Click Save Settings.
4.
a. Add a new Profile.
b. Configure the general details, header details, login
details, and footer details.
c. Click Save Settings.
5.
Test your settings.
a. Click a profile.
b. Click Show Preview.

Where to Go from Here

After installing the wireless controller, proceed to Chapter 3 to perform basic configuration
procedures.
Unpacking and Installation
ADVANCED > Users > Groups
ADVANCED > Users > Users
ADVANCE > Captive Portal > Wlan CP interface
association
ADVANCED > Captive Portal > Captive Portal Setup
ADVANCED > Captive Portal > Captive Portal Setup
25
DWC-1000 Wireless Controller User's Guide
Path in Web Management Interface See
Page
40
41
44
45
47