2 ] Removing The Components From The Paper Compartment Cover; Removing The Paper Guide Bar And Platen - Brother CB200 Service Manual

[ 2 ] Removing the components from the paper compartment cover

Removing the paper guide bar and platen

(1) If the printer base unit has not been removed, open the paper compartment cover by pulling
up its latch.
(2) Remove the retaining ring (E2) from each end of the paper guide bar, then remove the paper
guide bar from the paper stoppers R and L.
(3) Remove the platen stopper (one pan B taptite screw, M4x20).
(4) At the right end of the platen shaft, remove the platen gear by pulling its pawl outwards and
then remove the bushing R. At the left end, remove the pawled bushing L by pulling its pawls
outwards.
(5) Move the platen to the right (arrow
then take it out to the left (arrow
•
) to take out the left end from the platen frame L and
‚
).
III - 8