Cpu; Removing A Cpu - HP FM064UT#ABA Maintenance And Service Manual

CPU

This section describes how to remove and install a CPU.

Removing a CPU

To remove a CPU:
1. Power down the workstation (see
2.
Disconnect power from the workstation (see
3. Remove the side access panel (see
4.
If your system has an airflow guide, remove it (see
5. Remove the CPU heatsink (see
6.
Raise the CPU socket lever (1), and then open the cover (2), as shown in the following figure.
Figure 5-82
CAUTION:
extreme care and handle the CPU only by the edges.
7. Pull the CPU straight out of the socket (3), and store the CPU in a static free container in a safe
place where it cannot be damaged
156 Chapter 5 Replacing components
Predisassembly procedures on page
Removing the side access panel on page
Removing the CPU heatsink on page
Removing a CPU
Do not touch the CPU socket contacts or the gold pads underneath the CPU. Use
Predisassembly procedures on page
Removing the airflow guide on page
74).
74).
77).
109).
153).
ENWW