Hard Disk Drives; Lithium Coin Cell Battery; Customer Self-Repair - HP FM064UT#ABA Maintenance And Service Manual

Hard disk drives

Hard disk drives are fragile, precision components. Avoid subjecting them to physical shock and
vibration. The following guidelines apply to all drives, including failed drives, replacement drives, and
spares.
Do not remove hard disk drives from the shipping package for storage. Keep hard disk drives in
●
their protective packaging until they are mounted in the workstation.
Avoid dropping hard disk drives from any height.
●
If you are inserting or removing a hard disk drive, power off the workstation. Do not remove a
●
hard disk drive while the workstation is powered on or in standby mode.
Before handling a drive, be sure that you discharge static electricity. While handling a drive,
●
avoid touching the connector. For more information about preventing electrostatic damage, see
ESD information on page
To prevent possible ESD damage when the drive is installed, connect the drive power cable before
connecting the data cable. This discharges accumulated static electricity through the drive power
cable to the workstation chassis.
When inserting a drive, do not use excessive force.
●
Avoid exposing a hard disk drive to liquids, temperature extremes, or products with magnetic
●
fields such as monitors or speakers.

Lithium coin cell battery

The battery included with the workstation provides power to the real-time clock and has a lifetime of
about three years.
For instructions on battery removal and replacement, see
WARNING!
the battery is handled improperly. Do not disassemble, crush, puncture, short the external contacts,
dispose of in water or fire, or expose the battery to temperatures higher than 60° Centigrade (140°
Fahrenheit).
NOTE:
Do not dispose of batteries, battery packs, and accumulators with general household waste.

Customer self-repair

Under the Customer Self-Repair program, you can order a replacement part and install the part without
onsite HP technical assistance. See
as customer self-repair may be required for some components.
NOTE:
Some components, like the liquid cooling system, are not eligible for Customer Self-Repair
and must be returned to HP for service. Call HP Support for further instructions before attempting to
remove or repair this system.
ENWW
65.
This workstation contains a lithium battery. There is a risk of fire and chemical burn if
http://www.hp.com/go/selfrepair/
Battery on page 127.
for information on the program

Customer self-repair

69