Table of Contents
Advertisement
Converting to desktop configuration
This workstation can be operated in the mini-tower or the desktop configuration. Follow these steps to
convert to desktop configuration operation:
1.
With power removed from the workstation, remove the side access panel (see
access panel on page
2.
Remove the front bezel from the workstation (see
3.
Press gently on the edges of the optical drive bay filler panel, and remove it from the front bezel
as shown in the following figure.
Figure 5-85
4.
Rotate the filler panel 90 degrees to a horizontal position.
5.
Align the slots in the filler panel frame with the tabs in the front bezel. Press the optical drive filler
panel back into the front bezel until it snaps into place as shown in the following figure.
Figure 5-86
160
Chapter 5 Replacing components
77).
Removing the ODD bay filler panel
Installing the ODD bay filler panel
Removing the front bezel on page
Removing the side
82).
ENWW
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
