Optical Disk Drive (Mini-Tower Configuration); Removing An Optical Disk Drive From The Optical Bay (Mini-Tower Configuration) - HP FM064UT#ABA Maintenance And Service Manual

Optical disk drive (mini-tower configuration)

This section describes how to remove and install an optical disk drive in the workstation mini-tower
configuration.
Removing an optical disk drive from the optical bay (mini-tower
configuration)
1. Power down the workstation (see
2. Disconnect power from the workstation (see
3. Remove the side access panel (see
4. Remove the airflow guide (see
5. Remove the front bezel (see
6. Disconnect the data (1) and power (2) cables from the optical disk drive as shown in the following
figure.
Figure 5-15
88 Chapter 5 Replacing components
Predisassembly procedures on page
Removing the side access panel on page
Removing the airflow guide on page
Removing the front bezel on page
Disconnecting optical disk drive cables
Predisassembly procedures on page
82).
74).
74).
77).
109).
ENWW