Airflow Guide; Removing The Airflow Guide - HP FM064UT#ABA Maintenance And Service Manual

Airflow guide

This section describes how to remove and install the airflow guide used in the 6–DIMM versions of the
workstation.

Removing the airflow guide

1.
Power down the workstation (see
2. Disconnect power from the workstation (see
3. Remove the side access panel (see
4. Press the airflow guide release latches as shown in the following figure, and guide the airflow
guide out of the chassis.
Figure 5-37
ENWW
Predisassembly procedures on page
Removing the side access panel on page
Removing the airflow guide
Predisassembly procedures on page
Removing and installing components
74).
74).
77).
109